British-Cars.net

Welcome to the DMR Site for British Car Information.

Parts

MG parts spares and accessories are available for MG T Series (TA, MG TB, MG TC, MG TD, MG TF), Magnette, MGA, Twin cam, MGB, MGBGT, MGC, MGC GT, MG Midget, Sprite and other MG models from British car spares company LBCarCo.

MG MGB GT V8 Factory Originals Technical - Pertronix Upgrade.

I have just received my Petronix upgrade kit for the Mallory twin point dizzy.
Should I keep the Ballast Resistor?
Petronix recommend you remove the resistor but also say it is Ok to leave it!!
I have an unrated coil so I assume this will also be OK to keep. I believe any coil 0.6 Ohm or greater is acceptable.
Any help would be appreciated.
Dave
D M Tetlow

I ran a 76 BGT with pertronix (branded Aldon Ignitor) and ballast resistor for three years until I sold the car without any problems. I now have the same unit fitted to my non-ballasted '72 BGT for the past 2½ years and it still works as sweet as a nut.

I can't say I've noticed any significant difference in the performance between the two cars with different setups. One thing's for sure though, the Pertronix is a well worthwhile upgrade from a points system IMHO.

Sorry my answer is none-too-technical, but car electrickery is not my forte. ;-)

~Mike
Mike BGT

From what I read, keep the ballast if using the stock coil. Remove the ballast if using a 'Flame Thrower' or some upgraded coil.
Scott

Thanks Gents.
I will keep the resistor.
It will also mean that if I have a problem with the new setup I can easily refit the points.
Dave
D M Tetlow

This thread was discussed on 14/02/2007

MG MGB GT V8 Factory Originals Technical index